Front frame crossbar

On this picture the front frame crossbar is shown. The front frame is made out of tuning parts which are fully exchangeable. In this way it is not compulsory to purchase all the parts at once, you can upgrade your car part by part.

Why buy an Elcon Models tuning part?

Because the parts do improve the car is the simple answer.
It allows you to tune your RC car more specific according your personal wishes. The wishbones for example can be shifted between the axle mounts. With a simple clip the wishbone can be fixed on the desired position, easy as 1,2,3. By shifting the upper wishbone to the back and the lower wishbone to the front the angle of the steering swivel will be adjusted (caster). The RC car will now show a more stable behaviour, less nervous. You as a pilot will now have better controll over your car.

Also we do overthink small details. For example the holder for the brakecable, this part is adjustable to the left and right in the desired angle. Placement of the brake-servo on your car doesn’t matter, choose whatever fits you best! Mount your shock absorber on your desired spot more or less vertical, depending on the surface you will drive on.

Go take a look at one of our dealers near you, they can tell you more about our parts!

Wishbones you wished for...?
How close comes a 3-D impression? Is it realistic or different from the real part? Many people are wondering about this subject. Elcon Models lifts the veil of 3-D impressions by showing you the real part.

	The lower wishbone for the rear. For people who often visit our website already a well known item. Many drivers have high expectations, ours are not different! On the wishbone we engraved the amount of degrees for toe-out and toe-in. Double klick the picture to take a closer look.
	The rear wishbone mounted onto the RC car. The lower wishbone consists out of 3 parts allowing you to adjust and tune the car the way you like it. The part will be as all other parts delivered with a complete set of assembling materials.
	The lower wishbone viewed from the bottom. The rotation point for adjusting the toe-out and toe-in is situated as close as possible at the swivel. This is the spot where it should be, not at the bottomplate! For your comfort we engraved a degree-bow so the amount of toe-in and toe-out can be read from the wishbone directly

If you adjust toe-out/in the wheelbase and track width of the car will remain the same. This is the way you always wanted to tune your car. We also added caster in the wishbone. This will provide better driving behavior making the car less nervous.
After assembling the tuning of the part is easy. Just one single tool is needed to loosen or fasten the wishbone as the bolts are sunk. Never again after changing the toe-in and toe-out also adjusting the width of the wishbones due to your driving shaft. All this is a matter of the past.

Wishbones you wished for!