Wishbones you wished for...?
How close comes a 3-D impression? Is it realistic or different from the real part? Many people are wondering about this subject. Elcon Models lifts the veil of 3-D impressions by showing you the real part.

	The lower wishbone for the rear. For people who often visit our website already a well known item. Many drivers have high expectations, ours are not different! On the wishbone we engraved the amount of degrees for toe-out and toe-in. Double klick the picture to take a closer look.
	The rear wishbone mounted onto the RC car. The lower wishbone consists out of 3 parts allowing you to adjust and tune the car the way you like it. The part will be as all other parts delivered with a complete set of assembling materials.
	The lower wishbone viewed from the bottom. The rotation point for adjusting the toe-out and toe-in is situated as close as possible at the swivel. This is the spot where it should be, not at the bottomplate! For your comfort we engraved a degree-bow so the amount of toe-in and toe-out can be read from the wishbone directly

If you adjust toe-out/in the wheelbase and track width of the car will remain the same. This is the way you always wanted to tune your car. We also added caster in the wishbone. This will provide better driving behavior making the car less nervous.
After assembling the tuning of the part is easy. Just one single tool is needed to loosen or fasten the wishbone as the bolts are sunk. Never again after changing the toe-in and toe-out also adjusting the width of the wishbones due to your driving shaft. All this is a matter of the past.

Wishbones you wished for!