[11505] Wishbone rear, left

Partnumber: 11505

	The lowerwishbone itself consists of 2 parts, by this we achieved to change toe-in/out exactly where it should be. The hinge point when adjusting toe-in/out is situated directly under the center of the balldrive axle. By adjusting the angle of toe-in/out the length of the driving shaft will therefor remain the same.
	The angle can be adjusted continuously within a range of maximum 4 degrees in and 2 degrees out. For your convenience we engraved a degree bow on the wishbone, so no extra measurement tools are needed! Of course a stabilization bar can be mounted onto the wishbone. A special fixation was designed for this, see partnumber: 11801.

Also the existing raised shocker mount can be used easily on these wishbones providing a quick change
and more set-up possibilities, see: 18516.

The usual teflon bearings are already pressed in and the needed assembling materials are enclosed.
The special shaft from stainless steel comes with the package.